Thingiverse
XL6009 Case (red version)
von Mawkes
10
Downloads
12
Likes
0
Makes
It is modeled with 0.2mm tolerances.
Make sure to flip the Top 180 degrees in your slicer.
The board goes one way into the Bottom part. So if it doesn't fit, try to turn it around 180 degrees.
It is possible to look into the case from the top to see where IN and OUT is. In general the OUT is on the potentiometer-side of the board.
The case fits together quite snug so I don't believe any screws are neccesary to keep it together. I guess you could use hot glue it keep it shut "for good".
Enjoy.
Make sure to flip the Top 180 degrees in your slicer.
The board goes one way into the Bottom part. So if it doesn't fit, try to turn it around 180 degrees.
It is possible to look into the case from the top to see where IN and OUT is. In general the OUT is on the potentiometer-side of the board.
The case fits together quite snug so I don't believe any screws are neccesary to keep it together. I guess you could use hot glue it keep it shut "for good".
Enjoy.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
