XP Deus 2 Remote Case Remix

This is a remix of XP Deus 2 Remote Case https://www.thingiverse.com/thing:5491082. It allows the antenna to be completely enclosed within the Deus shaft and case. The antenna is routed inside the Deus shaft and enters the case through a hole in the case mounting stub. The case bottom is removable so the antenna can be pulled out the case bottom and then looped back up the side antenna tube to the top of the remote.

Case bodies printed using the STL’s labeled “inserts” require installation of three M3 x 5 mm OD threaded inserts. Two M3 x 6 mm long screws are used to attach the bottom. The top is attached using an M3 x 35 mm long screw or with a thumbscrew created by gluing an M3 x 40 mm long screw into the knob. Epoxy works well for installing the inserts and creating the thumbscrew.

Case bodies printed using the STL’s labeled “holes” do not require threaded inserts. They have 2 mm diameter holes to allow the use of M3 sheet metal screws or self-threading screws to attach