Xshot dread replacement cylinder

This is a replacement cylinder for the xshot dread and possibly the xshot xcess (havent tested)

This is intended for the dread drop cylinder mod, since buying more dreads and harvesting their cylinders isnt very economical

To assemble (after cleaning any stringing)

line up notch on turnything with the notch on the bottom of the cylinder, apply superglue to the stem of the turny thing and push all the way into the hole

MAKE SURE THE TWO NOTCHES ARE LINED UP, otherwise the cylinder wont align properly and darts wont fire

next, apply super glue to the top and glue it onto the top of the cylinder, make sure to align these properly, if anything, sand any sharp edges down

finally, glue the top pin into the hole in the top