Thingiverse
XT150 DOUBLE CONNECTOR HOUSING
by gwalmisley
1
Downloads
0
Likes
0
Makes
Connector housing for positive and negative terminal.
pla, print upright with 0.12 layer height
to install push one connector in first, then slide the other in. will require some force.
I have removed the arrow was modelled on the side. wasnt needed.
A tiny drop of ca once they are in case they pull out.
pla, print upright with 0.12 layer height
to install push one connector in first, then slide the other in. will require some force.
I have removed the arrow was modelled on the side. wasnt needed.
A tiny drop of ca once they are in case they pull out.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!