Thingiverse
XT60 and XT30 Battery Caps
von twistedartwork
9
Downloads
5
Likes
0
Makes
I made these battery caps to cover the conenctors of my 2S and 4S LiPo batteries. If printed in TPU they fit tight enough to not fall off but are not hard to remove. I added a small tab at the top to be able to grab them easier. They are modeled so that the can be printed upright without support.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
