XT60 LiPo Switch Holder

This is a XT60 on off switch for testing drone builds and configurations.

This is the switch I used from sparkfun. I removed the bottom nut and bent the leads to make it sit flat. There should be enough room if you choose to use the LED in this switch just make sure to add a 330 - 1k Ohm resistor to avoid burning it out.

https://www.sparkfun.com/products/11310

Vid https://www.youtube.com/watch?v=cqQNV9fTBVM

Used tree supports with floor/brim, without roof which made removing support easier with nylon. You really don't need nylon PLA will work fine but I didn't want to clean out the hotend.