Xterra Net Clip

So I just purchased a 2005 Nissan Exterra SUV and it has this cool netting in the back that you can use to stuff a few things into, like a litre or two of milk when you go to the grocery store. Unfortunately two of the clips in my new old car were missing so I spend 15 minutes making this one.

I just used clear PLA because that is what happened to be in the Creality K1 Max at the time but I will likely print it in grey to match the interior. Perhaps I will change materials too eventually because PLA is not the best for the high temperatures of a car but for now it will do.

I designed it to be printed on its side as shown. This is to give it maximum strength with the net pulling on it. If printed in a different direction, it would not be as strong and could separate along the layer lines when any load was applied. It feels quite strong printed this way.

250408 UPDATE - I also made a T-tool to help insert them because I found it a little difficult to twist with my fingers. Print the t