XTool Honeycomb Locator

I wanted a way to insure that the relative position of the XTool D1 Pro and the XTool Honeycomb I am using with it are always in the same position.

The holes are sized to slip fit the risers I made to compensate for the thickness of the Honeycomb.

To install you must put the risers in each Holder first, then slide the back into position and ten lower the front legs onto the risers. It is a very tight fit, it is supposed to be.

You will need to print 4 of the Short Leg Risers. Print them small end down and you won't need any supports.

Print 2 each of the Honeycomb Holders. Each one will need to be flipped to eliminate the need for supports.

I just added a variation of the design that can be cut by the XTool D1 using Lightburn.