XTool P2 slat hold down clips

Clips for the slats of the Xtool P2. One set is made specifically to hold 1.75mm thick material, primarily used to secure sheets of premium leatherette for cutting and engraving hat patches (such as the LoneStar premium leatherette).

There is another set that works the same way, but will hold material in the 3mm-6mm range.

There are clips for front/back holding, and sideways holding from the slat, and there is a long version of the sideways clip in case you place your slats in every-other spot (so it will reach the next slat over to hold down your material). You'll figure it out.