MakerWorld
Other Hobby & DIY
Go to Model
Xtool S1 Power supply mount
204
Downloads
53
Likes
123
Makes
An under desk mount for the Xtool S1 power supply. The 2 pieces slide on from the sides and need to be pushed over the small feet of the power supply so that it can't fall out. It attaches to the table with 3mm screws. (note, don't tighten the screws too hard so that the printed mount does not split) The design has a 16mm gab from power supply to table to not trap heat of the power supply. I printed the mount out of PLA, but PETG would be a better choice of material because it needs a bit of flex to get over the feet of the power supply. Also Print with 4 layers wall thickness for optimal strength.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
