Thingiverse
XY Calibration Ruler
von fascinacion3D
22
Downloads
14
Likes
0
Makes
Designed up this two-dimension ruler to quickly measure and calibrate small prints. I glued it to the edge of my desk to have it always on hand.
It includes:
-measurements 0-10mm in two directions
-circle diameters 1-10mm
-angles (°): 0, 10, 20, 30, 40, 50, 60, 70, 80, 90 and 45 (largest line)
-slots (mm): 0.5, 0.75, 1, 1.5, 2
It was inspired by this idea:
https://www.thingiverse.com/thing:25763
but without the 3rd dimension, with the measurements in the inside edge and starting xy measurements at the same point.
Let me know what do you thing about this/ if it can be improved :)
It includes:
-measurements 0-10mm in two directions
-circle diameters 1-10mm
-angles (°): 0, 10, 20, 30, 40, 50, 60, 70, 80, 90 and 45 (largest line)
-slots (mm): 0.5, 0.75, 1, 1.5, 2
It was inspired by this idea:
https://www.thingiverse.com/thing:25763
but without the 3rd dimension, with the measurements in the inside edge and starting xy measurements at the same point.
Let me know what do you thing about this/ if it can be improved :)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
