Y-axis Accelerometer Support

A simple yet effective way to mount your ADXL345 accelerometer to your bed to perform the Y-axis calibration of your input shaper. Procedure:print the object in the center of the bed with settings that maximize bed adhesion: high flow multiplier, high bed temperature, low z-offset, higher bottom-layer flow multiplier.IMPORTANT: do not turn off bed heater after print completion, or turn it back on immediately after, to avoid release from build plate!mount your ADXL345 onto the support with 2x M3 screws. The hole size is calibrated to be self-tapping: just push a bit when turning the screws!perform your input shaper calibration