Thingiverse
Y-Carriage
door Far_a_way
4
Downloads
6
Likes
0
Makes
Y-slide for an Anet E12, center distance 172mm,
with belt holder, on the top.
Once as a carriage with bearing blocks and
once as a spider with Heatbed carrier.
Bearing block or Heatbed carrier can be mirrored
during slicing, therefore only one piece.
Bearing blocks have 4 threads M3x15 each for fixing the
original plate holder.
Heatbed carrier printable without support.
Thread for screw M3x15 (4 pieces) is printed,
but you can also glue.
!! If it slides poorly, I use silicone spray or silicone oil, as this is compatible with plastics. !!
with belt holder, on the top.
Once as a carriage with bearing blocks and
once as a spider with Heatbed carrier.
Bearing block or Heatbed carrier can be mirrored
during slicing, therefore only one piece.
Bearing blocks have 4 threads M3x15 each for fixing the
original plate holder.
Heatbed carrier printable without support.
Thread for screw M3x15 (4 pieces) is printed,
but you can also glue.
!! If it slides poorly, I use silicone spray or silicone oil, as this is compatible with plastics. !!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
