Y-Motor-Holder

This modification adds two stability rods for the Y axis, removing the tension from the frame in order to reduce noise. Also the position of the belt is now supposed to be exactly in the middle (not off by 1.5 mm). You should also be able to use the old belt holder.

Beware, the front plate isn't symmetrical. The front filler assumes the left side to be 10.7 cm, the right side to be 10.4 mm wide.

The motor holder I printed did not fit into the holes, even though it exactly matched the template. Strange enough, the holes did fit. Therefore I added a 30 mm version (distance between rectangular holes) and rasped my print until it fit.

I did use some other thingies as templates:

Printing:
I did print tho motor holder upright (Y-Motor_holder_full.obj): The cone for the right rod almost curled away. I added a file with additional support, "ac" == anti-curling.

I also added files for printing the motor holder on its back. These are untested.

Motor_holder_full_ac.obj has an