Yakima Load Bar Tie-down Loop and Endcaps

I needed end-caps for my Yakima roof rack load bars. I added additional functionality to what is already a few great printed parts.

I made some tie-down spots to hold surfboards in the center of my roof rack - therefore I basically used the existing tie-down loop design, and punched a thru-hole. You then can slide the tie-down loops anywhere along the bar.

I have also included the "plain" endcap and matching hook endcap for continuity to keep the set looking consistent.

Not trying to rip-off any designs, just adding to what is already a helpful set of parts.