Yakima Q Tower Pad

Designed to replace knockoff pads for my Yakima round bar Q Towers. They are modeled after the "A" pads. Alignment isn't 100% but it does snap into place if using PLA. I would suggest going heavy on the walls and infill.

Test runs done in yellow sparkle PLA, end product will be done with Taulman 910 alloy or NylonX with 5-6 walls @ 60-70% infill. I do overkill.

I print with Cura's "Make Overhang Printable" with it set on the long flat side down, so the two teeth are pointing up. I've also included the FreeCad file so you can tweak it if you like. Good luck!