Yarn Holder Rev 1

My wife wanted a Yarn Holder, and I decided to design one for her.

It works well, and can hold large yarn cakes without issue.
Spins Freely, and has a large table to keep yarn from easily falling
Has places for rubber feet, to keep the base from sliding (Uses Pencil erasers for feet)

It uses the top of this Nostepinne, so full credit to them.
https://www.thingiverse.com/thing:2127625
This allows for ease of transfer from the Nostepinne to the Holder: simply remove the handle, and put the top on the holder

I've also seen these called: Yarn Caddy, Yarn Butler, and Yarn Dispenser

The main Table can be printed without support
The table holder and Base will need support to print, but it is minimal
Table holder should be printed upside down

Both Bearings need a nut on either side, otherwise over-tightening the nuts will cause excessive friction.

Printed with 20% infill
Support enabled
Outer Wall inset of 0.2 (using a 0.4mm Nozzle)


You will need:
1x M8 Threaded