YAS - Yet Another Spoolholder

i was about to Hang my Filament on the wall but i have this Crazy Idea of "everything on this Printer has to be designed by myself" so..... yeah its maybe the NR. 100³ Sppolholder on Thingiverse but its mine.

Print: 1x Wallmount, 2x Pipe, 1x Nut-Assist

additionally needed: 4x M5x50 Screw+Hex-Nuts

Install: place the nuts in the Nut-assist, insert it in one Pipe.
put the Screws in the Other pipe and put everything together with the Wallmount inbetween.

i use an Flexyshaft Bit-Holder to reach down to the Screws but you can use prettymuch anything that is long enough if you buy Phillips M5 Screws, a Srewdriver will suffice)

20.03.2020: added a thicker Nut-Assist for longer nuts like Nyloc that dont hold that good in the smaller one.