Thingiverse
Yazzo Female Clevis
door WilliamAAdams
29
Downloads
22
Likes
0
Makes
I have need for some common bar ends.
This thing forms a "clevis joint" I believe it is called.
The default size will allow you to slip an 8mm rod/dowel inside. The hole for the pin will fit an M3, or 3mm plastic filament probably. Good enough for prototyping. Printing on its side would probably be best for structural strength.
This thing forms a "clevis joint" I believe it is called.
The default size will allow you to slip an 8mm rod/dowel inside. The hole for the pin will fit an M3, or 3mm plastic filament probably. Good enough for prototyping. Printing on its side would probably be best for structural strength.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
