Yazzo Nut Socket Locking Clip

One of my primary design goals is to increase the 'rapid' part of my 'rapid prototyping' of hardware. One of the challenges I have faced while assembling structures that utilize laser cut panels, is the screw/nut combination which accompanies most laser cut panels slows me down. Putting all the screws into my MakerBot, for example, must add a significant amount to my build time.

This thing is meant to act as a substitute for all those screw/nut combinations that you typically need to use to assemble a DIY laser cut panel case of the captured nut/T-slot design.

As such, it can be utlized with any materials such as acrylic, glass or plywood. Everything is snap and friction fit.

While assembling the Yazzo MonkeyBot, http://www.thingiverse.com/thing:5219 there were a couple of comments on the clip design.

One question Wade had was 'what keeps the clips from vibrating apart'. In the first incarnation of clips, the answer would have been nothing really.

Then, hintss made t