Thingiverse
Yet another bowden clamp
door XylenC4
63
Downloads
34
Likes
1
Makes
I had some problems with my PFTE Bowen tube and the pure force of the BME bondtech extruder. The clamps which i used before (stolen from a Titan extruder clone, bad quality) wheren't that good and the tube slipped.
With a height of 1.75mm this bowden clamp is pretty tight. The BME extruder now skips steps before pushing the tube out.
You will get it off with a flat head screw driver.
With a height of 1.75mm this bowden clamp is pretty tight. The BME extruder now skips steps before pushing the tube out.
You will get it off with a flat head screw driver.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
