Thingiverse
Yet another filament filter
by kpr
1
Downloads
0
Likes
0
Makes
Filament filter
- made with two chambers
I. the bigger for dust cleaning
II. smaller one for oil (in case of PLA for bowden extruders).
Assembled with two M3 screws. For chambers use a cut of kitchen sponge "molytan". Place sponge pieces in top and bottom also, use thickness by 1-2mm bigger than part itself.
If you dont want use M3 screws, use zip tie over whole assembly. There are grooves for 3.2mm zip ties. Even 2.5mm works good.
- made with two chambers
I. the bigger for dust cleaning
II. smaller one for oil (in case of PLA for bowden extruders).
Assembled with two M3 screws. For chambers use a cut of kitchen sponge "molytan". Place sponge pieces in top and bottom also, use thickness by 1-2mm bigger than part itself.
If you dont want use M3 screws, use zip tie over whole assembly. There are grooves for 3.2mm zip ties. Even 2.5mm works good.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
