Thingiverse
Yet Another Phone Stand
von GreybeardFM
2
Downloads
0
Likes
0
Makes
Based loosely on the 'universal phone and tablet stand' from here... That was a bit lightweight for my needs. This one is a bit heavier.
Stand at 60 degrees, should hold most phones.
No supports, solid bodied, I printed in PLA at 20% infill. Plenty strong.
Stand at 60 degrees, should hold most phones.
No supports, solid bodied, I printed in PLA at 20% infill. Plenty strong.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!