Yet Another Propeller Balancer

Balanging propeller is vital for lowering vibrations on you RC system. Lower vibrations will improve longetivity of your motor and improve autopilot's/flight controller's performance.

This is a propeller balancer. It uses 2 pieces of 6mm diameter and 3mm height magnets to hold 56mm long shaft. Propeller clearance is designed for 10" props. With some limitations you can use this also for bigger propellers as well.

Print 2x holders.stl and one bottom.stl. Glue those together as shown in pictures and add magnets to those small holes.

You can use almost any printable material for this. Recommended print settings is 2 walls and 20% infill or stronger.

https://www.youtube.com/watch?v=JE1eKicm-ZM