Thingiverse
Yet Another Soap Tray
door rotf101
18
Downloads
15
Likes
1
Makes
This soap dish is inspired by cmar's (https://www.thingiverse.com/thing:2756347)and TK_DESIGN's (https://www.thingiverse.com/thing:1632910) soap dishes.
The footprint of the tray is based on the Dove bar soap box size (91 x 64mm). The pipe diameter this is supposed to clip onto is 21.86mm. The overall size is 91 x 91.
I used Solidworks 2015 for the part, and the SLDPRT is included.
UPDATE: I made a few more variants of this thing. It turns out PLA creeps more than I expected, so I made a version that takes a 5mm x 2mm cross section ziptie. There is also a variant without the hook and added little pointy feet to print and glue on afterwards to prevent water getting trapped underneath and attracting mold.
The footprint of the tray is based on the Dove bar soap box size (91 x 64mm). The pipe diameter this is supposed to clip onto is 21.86mm. The overall size is 91 x 91.
I used Solidworks 2015 for the part, and the SLDPRT is included.
UPDATE: I made a few more variants of this thing. It turns out PLA creeps more than I expected, so I made a version that takes a 5mm x 2mm cross section ziptie. There is also a variant without the hook and added little pointy feet to print and glue on afterwards to prevent water getting trapped underneath and attracting mold.
rotf101 publiceert ook op
19 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
