Yet another spool holder

Yeah, another spool holder, I just wanted to make mine and have it chainable, simply.

It differs from some others because I chose the have the spool be inside the holder rather than the commonly seen outside setup. It can accomodate

As you see on the picture, I made some filament storage previously. The aim is to replace the tube version of the storage with these chained holders, makes it easier to replace an empty spool in the middle of the storage!

It is meant to be as low as possible, this is why it is that long

Length: 148mm
Width: 78mm
Height: 25mm

For spool of minimum width: 46mm and maximum width of 57mm

Needed are 4 bearings:
- Outer: 22mm
- Inner: 8mm
- Height: 7mm

Included in the file is a **spool object, do not print it!** It is meant to be usefull for you in case you need to edit the spool holder and save you the time to design a spool.


https://youtu.be/BbW79Mn2jko