Yet Another Telescope Diagonal Holder

For a telescope that uses an M5 bolt and three screws that just push on the back to align (read: a cheap scope). Customize with the parameters in the SCAD file or use as-is.

I replaced the secondary on my department store scope with a much larger one, and the original crap holder wouldn't work anymore (it was too long). I measured it and cut off 15mm to make this one.

TODO: Note that I kinda suck and used the TOTAL height (not the 'center' of the mirror height) of the holder. You'll have to do a little math if you measure to the center and aren't duplicating and existing part.