Yet Another Universal Spool Holder

This spool holder should be able to fit most spools, while allowing for different ways of mounting them. It uses generic 608z bearings, which you will need to force into the screw parts, then proceed with the rod bits into the bearings themselves.

The rods are meant to fit into 6mm (longest radius) hexagons.

## Spool holder

You will need to print:
- male screw 1x (large flat side down, 0.2, 20% infill. no supports)
- female screw 1x (large flat side down, 0.2, 20% infill, no supports)
- rod x2 (vertical, 0.2, 60% infill, no supports)

## Mounts

### Adjustable desk mount

You will need to print:
- desk mount side x2 (flat, 0.2, 20% infill, no supports)
- desk mount screw x1 (vertical, 0.2, 60% infill, no supports, with brim)

The side has two holes, one threaded right and one threaded left. When facing two sides together, you will only need to put the screw through two facing holes. The screw itself is threaded correctly on each side. There is no point adding anot