Yet (not) Another Watch Stand

###**Yet (not) Another Watch Stand**


This is the model of a simple and minimal watch stand. It is based on existing watch stands, used for watch display. It is modular, as the base and the watch holder itself are two separate pieces that fit together.

###** Printing**


* I have tested this with an Anycubic Kobra S1, with very good results. Both PLA and PETG came out perfect. I suggest the use of PETG for extra durability in higher temperatures and UV irradiation, especially in case the watch stand is going to be used at a storefront exposed to sunlight.

* In my initial tests, I have been using 15% infill. This makes the watch holder a little bit more flexible, allowing even watches with tight bands/straps to be easily mounted on it, with no big effort and without causing any problems to the holder or to the watch itself. However, this low infill percentage, causes some vulnerabilities, and if the holder gets pushed hard when inserted in or removed from the base, it could probably