Thingiverse
Yoshi Trophy with custom supports
by brimstone326
459
Downloads
364
Likes
11
Makes
It took a couple tries to get the angled foot to print properly.
The supported Yoshi is about 90mm tall.
I printed it at 0.2Layers, 10% infill, and a 4 wall thickness .
I will probably bump the infill a bit on the next print.
This model was converted from here: http://www.models-resource.com/gamecube/ssbm/model/5337/
EDIT: 08/15/19 - Ran both files through Meshlab and Netfabb Basic. There was four small holes, but nothing breaking it up into multiple parts.
The supported Yoshi is about 90mm tall.
I printed it at 0.2Layers, 10% infill, and a 4 wall thickness .
I will probably bump the infill a bit on the next print.
This model was converted from here: http://www.models-resource.com/gamecube/ssbm/model/5337/
EDIT: 08/15/19 - Ran both files through Meshlab and Netfabb Basic. There was four small holes, but nothing breaking it up into multiple parts.
brimstone326 also publishes on
713 additional models across 3 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
