Thingiverse
You Looked Jibbit
von nakedcircus
96
Downloads
105
Likes
0
Makes
Got'em!
I originally printed at 20% and the finger broke as I was finessing it on the croc.
Printed at 75% the second time and it's pretty solid, but if you're too rough the finger will snap while you're putting it on the croc.
Print this upright, making sure the wrist is flat. Add rafts and add supports just under the Jibbitz piece. Takes like ~35min at 75%
I originally printed at 20% and the finger broke as I was finessing it on the croc.
Printed at 75% the second time and it's pretty solid, but if you're too rough the finger will snap while you're putting it on the croc.
Print this upright, making sure the wrist is flat. Add rafts and add supports just under the Jibbitz piece. Takes like ~35min at 75%
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
