Thingiverse
Yuki Air Cooler
door RiverFamily
46
Downloads
104
Likes
0
Makes
__I recommend using the Print Files (gcodes), adjust bed and nozzle temperature once the print starts to fit your filament needs__
Printer requirements:
0.6mm nozzle with at least 200x200x200mm build volume
---
body.gcode , uphere_body.gcode:
Two versions of Yuki's body, "body.gcode" fits any 120mm pc fan, "uphere_body.gcode" is specific for "Uphere 120mm pc fan". Run a "5V Uphere USB 120mm fan" at up to 12V with a "usb fan speed controller" to get maximum airwflow at low noise. Prints with 170g of PLA in 11h. Ender 3 v2 gives the best outer surface smoothness. Get original Yuki color with "Xightongzhilian silk blue PLA"
---
cap.gcode:
Prints with 25g of Polipropylene in 1h45m. Apply polypropylene adhesive tape to the heatbed to ensure part adhesion. Tested with Formfutura PP
---
icepack.gcode:
Prints with 100g of Polipropylene in 8h. Apply polypropylene adhesive tape to the heatbed to ensure part adhesion. Tested with Formfutura PP
---
Website:
Printer requirements:
0.6mm nozzle with at least 200x200x200mm build volume
---
body.gcode , uphere_body.gcode:
Two versions of Yuki's body, "body.gcode" fits any 120mm pc fan, "uphere_body.gcode" is specific for "Uphere 120mm pc fan". Run a "5V Uphere USB 120mm fan" at up to 12V with a "usb fan speed controller" to get maximum airwflow at low noise. Prints with 170g of PLA in 11h. Ender 3 v2 gives the best outer surface smoothness. Get original Yuki color with "Xightongzhilian silk blue PLA"
---
cap.gcode:
Prints with 25g of Polipropylene in 1h45m. Apply polypropylene adhesive tape to the heatbed to ensure part adhesion. Tested with Formfutura PP
---
icepack.gcode:
Prints with 100g of Polipropylene in 8h. Apply polypropylene adhesive tape to the heatbed to ensure part adhesion. Tested with Formfutura PP
---
Website:
RiverFamily publiceert ook op
15 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
