Thingiverse
Z-12B
por morris_lan
9
Descargas
16
Likes
0
Makes
This is for good display and fun. The design is similar to my Z-12A. The only difference is the Z-12B has a delta wing other than a swipe wing. If you like this model you should check out my Z-12A. Hope you will enjoy. Please file or sand off the sharp edges, before handing it to any children as a toy.
If your slicer have an option to use only "exterior support", then use it, because this could save you a lot of time and work. Using exterior support only means there will be no support structure in between the model. Therefore you will only have to clean up the supports that hold the wing and fuselage.
If your slicer have an option to use only "exterior support", then use it, because this could save you a lot of time and work. Using exterior support only means there will be no support structure in between the model. Therefore you will only have to clean up the supports that hold the wing and fuselage.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
