Z-axis cover

von Gabriel D. Barp · 3D Printer Parts

4.4k Downloads

1.4k Likes

3.6k Makes

Z-axis cover. Cover to make the printer look better and prevent filaments or dirt from causing problems. I created this cover because the others I found either didn't fit correctly or the part that was attached ended up being damaged. So I created my own, which is easy to install and has good resistance. The fit is good. Note: the shaft at the back of the printer is a little tricky to fit, I recommend starting with the part that is open at the front, attaching the 2nd part and then rotating to the correct position.

cover P1S BAMBULAB BAMBU BamBulab X1C x1c p1s P1S Bambu Bambu parts accessories design

Kategorie

3D Printer Parts

Quelle

MakerWorld

Veröffentlicht

21.02.2025

Aktualisiert

30.04.2026

Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz

Einteilig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 0/3

Drucker

FDM / FFF

Dateiformat

STL

Material

Software

Cura, PrusaSlicer o. Ä.

Noch keine Bewertungen

Noch keine Kommentare – sei der Erste!

Z-axis cover

Ähnliche Modelle

Zur Sammlung hinzufügen