Thingiverse
Z-Axis Guide (Prusa Clone)
von TheFlyingCaveman
9
Downloads
7
Likes
1
Makes
These were made for the Anet A8.
##### Notes
* All holes have a 30 degree taper on the plate facing side so as to make for easier printing. This does not appear to affect the strength and/or quality of the joint.
##### Planned Updates
* A plate to cover the entire top so that no holes are visible.
* To include a design that does not require external parts to be purchased.
* The inclusion of the model files so that anyone can edit them (via OnShape).
##### Required Parts
* 2 Bearings with an inner diameter of 8mm and an outer diameter of 22mm (I bought some from [Ebay](https://www.ebay.com/itm/Pack-of-10-Balls-Bearing-608ZZ-ID-Bore-8mm-22mm-7mm-608Z-By-VXB-Bearings-608/400072122346?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m2749.l2649))
##### Notes
* All holes have a 30 degree taper on the plate facing side so as to make for easier printing. This does not appear to affect the strength and/or quality of the joint.
##### Planned Updates
* A plate to cover the entire top so that no holes are visible.
* To include a design that does not require external parts to be purchased.
* The inclusion of the model files so that anyone can edit them (via OnShape).
##### Required Parts
* 2 Bearings with an inner diameter of 8mm and an outer diameter of 22mm (I bought some from [Ebay](https://www.ebay.com/itm/Pack-of-10-Balls-Bearing-608ZZ-ID-Bore-8mm-22mm-7mm-608Z-By-VXB-Bearings-608/400072122346?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m2749.l2649))
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
