Thingiverse
Z axis probe holder for solidoodle
di mikegi
7
Download
2
Likes
0
Makes
Probe holder for solidoodle.
**Note: My measurement for the X axis rod spacing was a tad off.. needed to file the slots a little bit.**
OpenSCAD included if you wish to customise.
Mounts on the x-axis.
Use 4 - 5 mm diameter bolt and nut (and perhaps a spring) to clamp to the x-axis rods.
Just fits between the belts. The smaller part could be a bit thinner in the next revision.
**Note: My measurement for the X axis rod spacing was a tad off.. needed to file the slots a little bit.**
OpenSCAD included if you wish to customise.
Mounts on the x-axis.
Use 4 - 5 mm diameter bolt and nut (and perhaps a spring) to clamp to the x-axis rods.
Just fits between the belts. The smaller part could be a bit thinner in the next revision.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
