Thingiverse
Z-Endstop (Adustable)
von MrHolyGas
3
Downloads
2
Likes
0
Makes
Adjustable Z-Endstop holder
-Desingned to be mounted on stepper motor.
-The "Base-Bot" part is to be mounetd on a left side so you'll have to mirror it if you
need the right side mounting.
-Center-to-Center distance of "Holder" holes is 19mm
-Height Bottom-to-Top goes from 54-64mm depending on the extension.
Requiered non-printable parts:
-Main Screw 1x M3x0,5 L29
-Nuts 5x M3
-Washers not required but recomended between "Base-Bot" and "Butto"
-Desingned to be mounted on stepper motor.
-The "Base-Bot" part is to be mounetd on a left side so you'll have to mirror it if you
need the right side mounting.
-Center-to-Center distance of "Holder" holes is 19mm
-Height Bottom-to-Top goes from 54-64mm depending on the extension.
Requiered non-printable parts:
-Main Screw 1x M3x0,5 L29
-Nuts 5x M3
-Washers not required but recomended between "Base-Bot" and "Butto"
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
