Thingiverse
Z Height Adjuster - For Rock Solid X Axis Prusa Mount
von TBRIshtar
6
Downloads
9
Likes
0
Makes
A clamp on Z Height adjuster for use with my Rock Solid mounts.
You need:
2x M3x25 Bolts
2x M3 nuts
2x M3 washers
1x small coil spring (nominal 3mm ID)
Notch in the dial so you can quickly see if Z height has shifted, or calculate no. of turns. With M3 bolts 1 turn is 0.5mm which is convenient.
You need:
2x M3x25 Bolts
2x M3 nuts
2x M3 washers
1x small coil spring (nominal 3mm ID)
Notch in the dial so you can quickly see if Z height has shifted, or calculate no. of turns. With M3 bolts 1 turn is 0.5mm which is convenient.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
