Thingiverse
Z PROBE FOR HYPERCUBE (V2)
von c_e_martinez
11
Downloads
28
Likes
0
Makes
This is another simple autoleveling pasive mechanism for hypercube.
These are parameters for Marlin config:
Distance from hotend:
X = -41.5mm (41.5mm to left side)
Y = 0
This thing was tested and is working fine. This is stronger than my before version.
These are parameters for Marlin config:
Distance from hotend:
X = -41.5mm (41.5mm to left side)
Y = 0
This thing was tested and is working fine. This is stronger than my before version.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
