Thingiverse
Z-Probe mount for CTC Bizer; Flashforge Creator; Makerbot Replicator
von MarcImay
7
Downloads
5
Likes
0
Makes
This is a 12mm diameter Z-Probe mount for my CTC Bizer. If you want to use it you'll need an M3x20mm, an M3x18mm screw and a M3 nut.
V2 is a little bit smaler. The offset of V2 from the next extruder is aproximatly X+35.7 Y+2.0.
V2 is a little bit smaler. The offset of V2 from the next extruder is aproximatly X+35.7 Y+2.0.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
