Z-Scale Christmas Tree Train Ring

Tree ring for a Z-Scale train to go around a Christmas Tree. designed in sections to allow it to be printed without supports. The outer ring has posts and holes to allow each to align with the next it also has a channel on the top to allow you to install lights. The inner sections will then lock into the outer portion by pushing in from the outside There is in outer ring with switch section that allows you to install the batter pack for the lights or run the wires through. The inner portion also labeled as such has a cut out to allow the wires to go though. These are not needed but do create a cleaner look

you will need 12 outer pieces and 12 inner pieces to complete the circle. Approx width is 24 inches with approx 6 ft of track required.