Z Stabilizer for Anet A8

I designed this part to minimise the z to y stability of a anet a8. The stock setup only utilizes the all thread and 8 nuts to connect the bed to the acrylic frame. Then the front plate only has a half hole to clamp to with nuts and washer. This part adds more support points between the bed and frame by utilizing the all-thread and existing holes. I noticed while browsing thingiverse there have been quite a few attempts at stabilizing this particular problem but none have fit my needs.
I have been through many iterations of this design and i am pleased enough with this final design to fit my machine. I did use several stl files of the acrylic frame to test the fit virtually.

Print Instructions
Print with a brim! The part could have a tendency to rock back and forth, Causing a rounded bottom that is not desired.

Parts
This uses all original parts and some of the extra m3 screws and nut.

Warnings
DO NOT OVER TIGHTEN THE ALL-THREAD NUTS! This is merely a support intended to