Thingiverse
ZANGETSU - BLEACH
von BoilerBuilds
1
Downloads
10
Likes
0
Makes
I didn't like any of the models I found on the internet, so I decided to make my own. This is designed to be printed using a single material printer, which I haven't seen yet. Some parts might require minor gluing, but most pieces use standard size toothpicks as connecting rods.
*** Full assembly is about 5.5 feet (1.5 meters) long
** If supports are used at any point, it is crucial to disable them inside the connecting rod slots or they will never come out.
* More refined layer height helps give a metallic look to the blade, especially with matte black filament.
*** Full assembly is about 5.5 feet (1.5 meters) long
** If supports are used at any point, it is crucial to disable them inside the connecting rod slots or they will never come out.
* More refined layer height helps give a metallic look to the blade, especially with matte black filament.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
