ZD Racing EX-07 control arm

This is a control arm for the EX07, modeled exactly after the real part. Print this in carbon fiber filament of your choice with 50-100% infill (recommend 100). Much stronger than stock, and requires minimal modifications to fit. You may need to drill some of the holes out (mainly the one for the hinge pin) out a little bigger. Sway bars fit flush without modification. You may also need to trim a little off the left side (hinge pin side) so the axle drive cups don't make contact under full compression. This part can be mirrored for both front and rear control arms for the EX07.