ZENDRONE printable Hexacopter

I wanted to film our products from above - checking the market looked like Count Dracula was chief Designer of all Multicopter Drones. So i decided to make one on my own.

I don´t have any clue about building a drone - but i´m quite good with pentagons & hexagons - so this is very WIP - i will build and test it in the next weeks - but perhaps sombody from the multicopter experts have some good ideas for a newbie.

i like the Idea about building light parts with very low infill percentage - and if you ever tried to demolish a massive part with a 10% Infill you know how durable this could be.

The sizes are fitting the Rep 2 build Area -

Everything is build for 18/16mm Carbon Tubes or Aluminium Tubes!

The electronic mount is build around a APM 2.5 without case but it should work with all flight controllers! - where to put the other componets i have to figure out. The ESC could be put in the Motor Mounts.

The Motor Mounts are quite big because i hav