Thingiverse
Zeptocore case
von Pabloantxon
5
Downloads
10
Likes
0
Makes
Case for the amazing Infinite Digits Zeptocore.
Created from scratch, but the design of the keys was heavily inspired in Justinkowski's Pocket Operator Case
https://www.thingiverse.com/thing:3569086
******I USE MINE WITH A POWER BANK, WITHOUT THE BATTERIES, so the bottom lid is totally closed. If you want to use the batteries, you are going to have to either add two holes for passing the pins through, or make a big square hole on the lid so it fits the whole battery holder.
The part called ZeptocoreCaseLights.stl should be printed in transparent filament. Once printed, push them into the holes in the keys (do not take them apart, it is all one part that fits into the keys), and place the keys on the case top, from inside. Then insert the Zeptocore, and finally close it with the bottom lid.
The bottom lid might look like it is not going to fit, but with patience, care and pushing in the right places it ends up fitting just fine.
Feel free to print and sell this design (just
Created from scratch, but the design of the keys was heavily inspired in Justinkowski's Pocket Operator Case
https://www.thingiverse.com/thing:3569086
******I USE MINE WITH A POWER BANK, WITHOUT THE BATTERIES, so the bottom lid is totally closed. If you want to use the batteries, you are going to have to either add two holes for passing the pins through, or make a big square hole on the lid so it fits the whole battery holder.
The part called ZeptocoreCaseLights.stl should be printed in transparent filament. Once printed, push them into the holes in the keys (do not take them apart, it is all one part that fits into the keys), and place the keys on the case top, from inside. Then insert the Zeptocore, and finally close it with the bottom lid.
The bottom lid might look like it is not going to fit, but with patience, care and pushing in the right places it ends up fitting just fine.
Feel free to print and sell this design (just
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
