Thingiverse
Zerbob's IR Mount
von Zerbob
20
Downloads
12
Likes
2
Makes
UPDATED:
With suggestions from /r/hoggit this design has been overhauled. For adhered to your headset a velcro strip is recommended. This design is much lighter and easier on materials with no bridging. Holes are 5mm in diameter allowing for LEDs over 5mm to be glued down if desired. Small raised rectangle is for a Micro USB-B breakout board to power your LEDs of choice.
With suggestions from /r/hoggit this design has been overhauled. For adhered to your headset a velcro strip is recommended. This design is much lighter and easier on materials with no bridging. Holes are 5mm in diameter allowing for LEDs over 5mm to be glued down if desired. Small raised rectangle is for a Micro USB-B breakout board to power your LEDs of choice.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
