Thingiverse
ZeroBox, Raspberry Pi Zero fastened enclosure
von rvalle
65
Downloads
37
Likes
0
Makes
ZeroBOX
========
Raspberry Pi Zero box designed for Plastic Inserts and M2.5 screws.
The Fasteners that I have used are [PSM Heat-Lok](http://www.psminternational.com/en/product/detail.aspx?typeid=1&proid=32). I use my soldering iron to insert them, in this design is a bit difficult as some section of the wall housing the insert are thinner than usually recommended.
Your printer must be cable of printing solid walls of 1mm thickness.
I have printed this with an UP! Box with ABS an 0.1mm layer thickness.
This design can easily be modified for self tapping screws, allow access to GPIO connector and better ventilation.
========
Raspberry Pi Zero box designed for Plastic Inserts and M2.5 screws.
The Fasteners that I have used are [PSM Heat-Lok](http://www.psminternational.com/en/product/detail.aspx?typeid=1&proid=32). I use my soldering iron to insert them, in this design is a bit difficult as some section of the wall housing the insert are thinner than usually recommended.
Your printer must be cable of printing solid walls of 1mm thickness.
I have printed this with an UP! Box with ABS an 0.1mm layer thickness.
This design can easily be modified for self tapping screws, allow access to GPIO connector and better ventilation.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
