Thingiverse
Zig Zag Planters
by ThinAir3D
5
Downloads
5
Likes
0
Makes
These planters were modeled to be printed in vase mode. If you print them as is you will waste a lot of filament!
If you want more than 1 perimeter, instead of using vase mode you can use 0% infill and 0 top layers, then just choose how many perimeters you want. It won’t technically print the same way as vase mode (a continuous line), but will still get the job done!
**This design is uploaded with a non-commercial license. Purchasing this file does not grant you the right to sell commercially.
If you would like to consider gaining access to ALL of my models and the rights to print and sell them, you can check out my Patreon at
https://www.patreon.com/thinair3D
If you want more than 1 perimeter, instead of using vase mode you can use 0% infill and 0 top layers, then just choose how many perimeters you want. It won’t technically print the same way as vase mode (a continuous line), but will still get the job done!
**This design is uploaded with a non-commercial license. Purchasing this file does not grant you the right to sell commercially.
If you would like to consider gaining access to ALL of my models and the rights to print and sell them, you can check out my Patreon at
https://www.patreon.com/thinair3D
ThinAir3D also publishes on
82 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
