Thingiverse
Zip tie container wallmount
von WyMafia
11
Downloads
3
Likes
0
Makes
Made for holding:
2x 100mm
2x 200mm
2x 300mm
Does use quite a bit of filament
4mm screw holes for mounting it on a wall. Screw holes are purposely not tapered, so you can level it in case your holes are slightly off.
2x 100mm
2x 200mm
2x 300mm
Does use quite a bit of filament
4mm screw holes for mounting it on a wall. Screw holes are purposely not tapered, so you can level it in case your holes are slightly off.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
